Maschine
horizontal panel sizing saws
Anwendung
for stack cuts in raw and plastic-laminated panels
Ausführung
vibration and noise damping ornaments
additional expansion slots
tooth configuration: triple chip / flat "TR-F"
cutting material: HW HL Board 04 plus
additional expansion slots
tooth configuration: triple chip / flat "TR-F"
cutting material: HW HL Board 04 plus
Vorteile
for highest performance demands
reduced cutting pressure and power consumption thanks to optimized cutting geometry
extremely low-noise and smooth running thanks to vibration and noise damping ornaments as well as special expansion slot combinations
clearly increased edge life thanks to improved HW grade
reduced cutting pressure and power consumption thanks to optimized cutting geometry
extremely low-noise and smooth running thanks to vibration and noise damping ornaments as well as special expansion slot combinations
clearly increased edge life thanks to improved HW grade
Hinweis
stack height: Ident-No. 192629 up to max. 190 mm / Ident-No. 192631 up to max. 210 mm / Ident-No. 192633 up to max. 215 mm
recommended projection: 20-30 mm
NL**- Combi7 = 2/9/110 + 2/10/80 + 2/11/85 + 2/11/115 + 2/11/148 + 2/14/100 + 2/14/125 + 2/19/120